Inexpensive and precise targeting of the thermal imaging attachment with the help of a target pad that can be placed anywhere.
With the ongoing development and above all the amendment of the gun law, more and more hunters are considering a thermal imaging device. Because that way, even in the most difficult weather and light conditions, it can be addressed safely.
However, the shot should always be safe even when using a thermal imaging attachment. In connection with the usual firearm and optics but a new thermal imaging device, prior calibration is therefore urgently recommended. Possible differences between the intended target point and the actual shot hit are to be ruled out as far as possible in order to avoid missed shots.
With the newly developed thermal imaging target pads, this calibration is particularly efficient and inexpensive.
Simply tear open the packaging (foil), remove the pad, peel off the protective film on the back and attach the target pad to the desired location. The pad reaches its optimal calibration temperature of 38°C within a few minutes.
Then aim the thermal pad with the gun-mounted thermal imaging device and optimize the thermal view. After only 2-3 test shots, thanks to the round shape and small diameter of the pad, unwanted shot deviations between the bullet holes and the geometric center of the pad can be optimally determined.
The activation of the heat pads begins solely through contact with the air. The specific combination of the ingredients contained in the heat pads (especially activated carbon) ensures that they are automatically heated without any further action.